On Tue, Jul 13, 2010 at 18:26, ovvenkat <ovvenkatesan@gmail.com> wrote:Hi,
I dont know whether I can post this question here or not.. But, I dont know any other place. I hope any one can help here .
I recently bought the Sangoma A101 - 1 port E1/T1 card and installed on CENT OS 5.4. I am using it for E1 PRI line in INDIA.
Here is the output of "wanrouter status" command
Devices currently active:
wanpipe1
Wanpipe Config:
Device name | Protocol Map | Adapter | IRQ | Slot/IO | If's | CLK | Baud rate |
wanpipe1 | N/A | A101/1D/A102/2D/4/4D/8| 50 | 0 | 1 | N/A | 0 |
Wanrouter Status:
Device name | Protocol | Station | Status |
wanpipe1 | AFT TE1 | N/A | Connected |
Here is the output of "wanpipemon -i w1g1 -c Ta" the
***** w1g1: E1 Rx Alarms (Framer) *****
ALOS: OFF | LOS: OFF
RED: OFF | AIS: OFF
LOF: OFF | RAI: OFFWhat RED alarm? :) Its fine, your E1 is up_______________________________________________
***** w1g1: E1 Rx Alarms (LIU) *****
Short Circuit: OFF
Open Circuit: OFF
Loss of Signal: OFF
***** w1g1: E1 Tx Alarms *****
AIS: OFF | YEL: OFF
***** w1g1: E1 Performance Monitoring Counters *****
Line Code Violation : 1163
Far End Block Errors : 0
CRC4 Errors : 0
FAS Errors : 3
Rx Level : > -2.5db
I spoke with my telco, they checked the line and there is no issue. I don't know what to do? Pls anyone help me?
Regards,
Venkat.
FreeSWITCH-users mailing list
FreeSWITCH-users@lists.freeswitch.org
http://lists.freeswitch.org/mailman/listinfo/freeswitch-users
UNSUBSCRIBE:http://lists.freeswitch.org/mailman/options/freeswitch-users
http://www.freeswitch.org
--
wasim h. baig | principal consultant | convergence pk | +92 30 0850 8070 | peace be upon you ...
_______________________________________________
FreeSWITCH-users mailing list
FreeSWITCH-users@lists.freeswitch.org
http://lists.freeswitch.org/mailman/listinfo/freeswitch-users
UNSUBSCRIBE:http://lists.freeswitch.org/mailman/options/freeswitch-users
http://www.freeswitch.org