Good afternoon

 

I'm new to freeSWITCH and have setup my freeSWITCH successfully, from the latest pre-compiled version (windows).  I have a successfully configured a SIP gateway (provider voipfone), but when I dial into the PSTN number, just to try and route to one of the default build extensions 1000 (I also tried the IVR) I get this error:

 

2012-10-12 15:41:16.997549 [ERR] switch_core_session.c:408 Could not locate channel type 1000 XML default

2012-10-12 15:41:16.997549 [NOTICE] switch_ivr_originate.c:2599 Cannot create outgoing channel of type [1000 XML default] cause: [CHAN_NOT_IMPLEMENTED]

 

I've taken the code straight out of the book, and just added my SIP username and password, so I can't understand why it won't route through?  Rather than past in code here, I have put the output from a clean startup in a word file, and also put the external sip_profile xml, and also the public directory xml file into the same document too.

 

http://www.beyondmarathon.com/routes/freeswitch_output.docx

 

voipfone was not a provider listed in the wiki, but given I have been able to get the gateway registered then I assume it is ok, and there must be a config issue somewhere?

 

Any help would be greatly appreciated.

 

Regards

 

Richard Weremiuk

_________________________________________________________________________
Professional FreeSWITCH Consulting Services:
consulting@freeswitch.org
http://www.freeswitchsolutions.com

FreeSWITCH-powered IP PBX: The CudaTel Communication Server
http://www.cudatel.com

Official FreeSWITCH Sites
http://www.freeswitch.org
http://wiki.freeswitch.org
http://www.cluecon.com

FreeSWITCH-users mailing list
FreeSWITCH-users@lists.freeswitch.org
http://lists.freeswitch.org/mailman/listinfo/freeswitch-users
UNSUBSCRIBE:http://lists.freeswitch.org/mailman/options/freeswitch-users
http://www.freeswitch.org