Just to clarify: each sip profile binds to ONE and only ONE IP address. That can be ipv4 external, local, ipv6, whatever, but you need a separate profile for EACH IP you wish to get calls on.
-Avi
On Tue, Jun 28, 2011 at 11:00 AM, Steven Ayre <steveayre@gmail.com> wrote:
You can use SIP on FS on IPv4, IPv6, or both. You can even bridge calls inbetween the two (as long as you avoid bypass_media).
When you create a SIP profile it binds to a specific IP, you just need to put the relevant IPv4/IPv6 IP there. Then treat the profiles as normal. ACLs also support IPv6 addresses.
Not sure about what the support is in other modules such as mod_h323
-SteveOn 27 June 2011 17:15, bill evergreen <bill.evergreen@gmail.com> wrote:
Hello,
I intend to setup a little FreeSWITCH test-environment. Does FreeSWITCH care about beeing connected to an IPv4- OR IPv6-isp (it should be possible to operate the same environment under IPv4 OR IPv6) ?
ong
Thank's a lot for any feedback!
Bill
PS
I am new to FreeSWITCH :-)
_______________________________________________
Join us at ClueCon 2011, Aug 9-11, Chicago
http://www.cluecon.com 877-7-4ACLUE
FreeSWITCH-users mailing list
FreeSWITCH-users@lists.freeswitch.org
http://lists.freeswitch.org/mailman/listinfo/freeswitch-users
UNSUBSCRIBE:http://lists.freeswitch.org/mailman/options/freeswitch-users
http://www.freeswitch.org
_______________________________________________
Join us at ClueCon 2011, Aug 9-11, Chicago
http://www.cluecon.com 877-7-4ACLUE
FreeSWITCH-users mailing list
FreeSWITCH-users@lists.freeswitch.org
http://lists.freeswitch.org/mailman/listinfo/freeswitch-users
UNSUBSCRIBE:http://lists.freeswitch.org/mailman/options/freeswitch-users
http://www.freeswitch.org