I'm behind NAT.
if you are not behind any nat then as long as you run your profile on 5060, the source port on every packet will be 5060.
If you *are* behind nat the nat mapping will pick a random port unless you have a firewall that allows you to set specific mappings.
On Wed, Feb 4, 2009 at 6:26 AM, Jonas Gauffin <jonas.gauffin@gmail.com> wrote:
_______________________________________________HelloI'm trying to make outbound calls through my gateway provider.My calls got rejected and I asked them why.Apparently I need to use 5060 as source port, since they validate both my IP and the port that the messages come from.Is this possible with freeswitch? If so, what config settings should I set?Regards,Jonas
Freeswitch-users mailing list
Freeswitch-users@lists.freeswitch.org
http://lists.freeswitch.org/mailman/listinfo/freeswitch-users
UNSUBSCRIBE:http://lists.freeswitch.org/mailman/options/freeswitch-users
http://www.freeswitch.org
--
Anthony Minessale II
FreeSWITCH http://www.freeswitch.org/
ClueCon http://www.cluecon.com/
AIM: anthm
MSN:anthony_minessale@hotmail.com
GTALK/JABBER/PAYPAL:anthony.minessale@gmail.com
IRC: irc.freenode.net #freeswitch
FreeSWITCH Developer Conference
sip:888@conference.freeswitch.org
iax:guest@conference.freeswitch.org/888
googletalk:conf+888@conference.freeswitch.org
pstn:213-799-1400
_______________________________________________
Freeswitch-users mailing list
Freeswitch-users@lists.freeswitch.org
http://lists.freeswitch.org/mailman/listinfo/freeswitch-users
UNSUBSCRIBE:http://lists.freeswitch.org/mailman/options/freeswitch-users
http://www.freeswitch.org