Are you having them come into the internal profile? (i.e. port 5060?) If so then make some changes:

In conf/sip-profiles/internal.xml remove line:

In conf/vars.xml change this line to false:

<X-PRE-PROCESS cmd="set" data="internal_auth_calls=true"/>

Restart the profile and try again. NOTE: this leaves you pretty much wide open, so I would recommend you make sure that your dialplan is locked down so that you don't get toll frauded...

-MC

On Wed, Nov 17, 2010 at 2:26 PM, Neil J. Macvicar <neilm@kernelspace.co.uk> wrote:

Hello,

I have recently compiled and installed freeswitch, and it is running with no problems. I can make and receive calls via my defined gateway with my provider, VoipTalk.

My problem lies in that I have several DIDs with Voiptalk, and I have the option of routing them directly to my IP address as a SIP call. When I do this and call one
of the numbers, not much happens. So I put sofia into debug sip mode, and observed the same message repeating :-

------------------------------------------------------------------------
send 866 bytes to udp/[217.14.138.126]:5060 at 22:22:15.236893:
------------------------------------------------------------------------
SIP/2.0 407 Proxy Authentication Required

217.14.138.126 being one of my providers' machines.

What i'd like to know is how can I get freeswitch to stop asking for authentication to my provider, without putting a blacket "allow" in the domain ACLS.
Voiptalk have a large number of IP addresses that they use to send the outbound calls, so listing them all would be a chore.

Thanks in advance,
--Neil.

_______________________________________________
FreeSWITCH-users mailing list
FreeSWITCH-users@lists.freeswitch.org
http://lists.freeswitch.org/mailman/listinfo/freeswitch-users
UNSUBSCRIBE:http://lists.freeswitch.org/mailman/options/freeswitch-users
http://www.freeswitch.org