You can use SIP on FS on IPv4, IPv6, or both. You can even bridge calls inbetween the two (as long as you avoid bypass_media).

When you create a SIP profile it binds to a specific IP, you just need to put the relevant IPv4/IPv6 IP there. Then treat the profiles as normal. ACLs also support IPv6 addresses.

Not sure about what the support is in other modules such as mod_h323

-Steve



On 27 June 2011 17:15, bill evergreen <bill.evergreen@gmail.com> wrote:
Hello,

I intend to setup a little FreeSWITCH test-environment.  Does FreeSWITCH care about beeing connected to an IPv4- OR IPv6-isp (it should be possible to operate the same environment under IPv4 OR IPv6) ?
ong

Thank's a lot for any feedback!

Bill



PS
I am new to FreeSWITCH :-)



_______________________________________________
Join us at ClueCon 2011, Aug 9-11, Chicago
http://www.cluecon.com 877-7-4ACLUE

FreeSWITCH-users mailing list
FreeSWITCH-users@lists.freeswitch.org
http://lists.freeswitch.org/mailman/listinfo/freeswitch-users
UNSUBSCRIBE:http://lists.freeswitch.org/mailman/options/freeswitch-users
http://www.freeswitch.org