You need to make sure you include each file/directory you want. Only one file is loaded by default and that specifies which other files to load. If you take a look at the standard config files, you should see what I'm talking about.

-Avi

On Wed, Aug 21, 2013 at 10:27 AM, Grant Bagdasarian <GB@cm.nl> wrote:

Hello,

I’ve started to configure FS from scratch by making my own configuration files, based on the files in the vanilla directory.

I don’t know if this is normal behavior but whenever I start FreeSwitch and check the freeswith.xml.fsxml file, the XML elements in the freeswitch/conf/customsbc/freeswitch.xml and vars.xml are not shown. Only the commentary is shown in this .fsxml file. Is this normal?

Also when running the netstat –unlp command, I see freeswitch isn’t binding to the address defined in the bind_server_ip variable. Is this because the configuration isn’t properly loaded?

Htop shows FS is running.