Hi Bote,

I believe priority works in a similar way to metric (i.e. lower comes first), so -20 (most favorable scheduling) to +19 (least favorable scheduling).

-rp                    -- enable high(realtime) priority settings
-lp                    -- enable low priority settings
-np                    -- enable normal priority settings (system default)
Source: https://wiki.freeswitch.org/wiki/Command_line

Hope this helps.

Thanks,
Shaun
From: freeswitch-users-bounces@lists.freeswitch.org [freeswitch-users-bounces@lists.freeswitch.org] on behalf of Bote Man [bote_radio@botecomm.com]
Sent: 04 September 2015 15:54
To: FreeSWITCH Users Help
Subject: [Freeswitch-users] FS priority

I’m trying to set the priority on a new FreeSWITCH installation built from master on Debian 8 running on bare metal. It is currently running at “very low” priority according to Resource Monitor in the GUI and ‘top’ reports FS is running at priority = -2 (that’s negative two) and nice = 19

 

So with the way FreeSWITCH is now launched by systemd is it considered a service or a user application that is simply run in the background?

 

This affects how systemd treats its control groups and priority and how I will go about troubleshooting this.


Thanks.

 

Bote

 


______________________________________________________________________
This message has been checked for all known viruses by MessageLabs Virus Scanning Service.
______________________________________________________________________

______________________________________________________________________
This message has been checked for all known viruses by MessageLabs Virus Scanning Service.
______________________________________________________________________