Hello Richard,
you would do this like the following in the dialplan:
<action application="set"
data="PEER_IP=200.100.200.100"/>
<action application="bridge"
data="h323/012345678@${PEER_IP}"/>
The PEER_IP is the remote Server you would like to place a call
to. Thus with every dialplan you can call a different h323 server.
With inbound H323 from an external server, you can just route by
destination_number. I am not sure, but I think you will have to
have the external H.323 server IP in you domains section of the
acl.conf.xml. We also had to rewrite some number fields, but this
can be a problem of the other side of the line.
We use H.323 with Freeswitch this since more than 2 years in a
productive environment with lots of traffic. It's just running
like a charm. We only had problemes on the opposite part of the
line (a legacy PBX).
Best regards
Peter
On 12/17/13 21:13, Richard Mace wrote:
Peter,
Thanks for your reply.
_________________________________________________________________________
Professional FreeSWITCH Consulting Services:
consulting@freeswitch.org
http://www.freeswitchsolutions.com
FreeSWITCH-powered IP PBX: The CudaTel Communication Server
http://www.cudatel.com
Official FreeSWITCH Sites
http://www.freeswitch.org
http://wiki.freeswitch.org
http://www.cluecon.com
FreeSWITCH-users mailing list
FreeSWITCH-users@lists.freeswitch.org
http://lists.freeswitch.org/mailman/listinfo/freeswitch-users
UNSUBSCRIBE:http://lists.freeswitch.org/mailman/options/freeswitch-users
http://www.freeswitch.org
--
With kind regards
Peter Steinbach
Telefaks Services GmbH
mailto:lists (att) telefaks.de
Internet: www.telefaks.de