I do understand the importance of NAT, i just want to know where it sends ICMP ping (refer to NiK reply below) to compute NAT type? Right now i am enhancing a few FS modules for a specific business model. Once it is done and fully tested, i would put it in production, where i have to take care of NAT issues as well. So, if i know its NAT detection mechanism, it would be easier for me to configure it properly during production deployment.

Also if my employer approves, i would like to share my customization (fully or partially) with FS community. How can i get a developer account? What else is required to become an official FS developer?

Thank you.


On Wed, Jun 3, 2009 at 7:18 PM, Brian West <brian@freeswitch.org> wrote:
You shouldn't have to use the switch anymore.  That is unless you just wanna skip that check.

/b

On Jun 3, 2009, at 12:09 AM, Muhammad Shahzad wrote:

I had to upgrade again svn revision to use this switch, but it works.

Thank you.

-- Meet us at ClueCon!  http://www.cluecon.com





_______________________________________________
Freeswitch-users mailing list
Freeswitch-users@lists.freeswitch.org
http://lists.freeswitch.org/mailman/listinfo/freeswitch-users
UNSUBSCRIBE:http://lists.freeswitch.org/mailman/options/freeswitch-users
http://www.freeswitch.org




--
Muhammad Shahzad
-----------------------------------
CISCO Rich Media Communication Specialist (CRMCS)
CISCO Certified Network Associate (CCNA)
Cell: +92 334 422 40 88
MSN: shari_786pk@hotmail.com
Email: shaheryarkh@googlemail.com