Hey all,

 

I have successfully managed the following setup … at least to a certain extent.

 

Phone line -> CISCO VIC2-4FXO -> CISCO 2811 -> Sip -> Windows Server 2008 -> FreeSwitch -> Managed IVR (IAppPlugin)

 

When I dial say the phone line’s number (49794) it connects me to extension 1024 which has the managed C#.NET IVR sitting behind it. That works fine while everything is happy. However, when I hang up my phone. My IVR is still happily talking to no one until the relevant timeouts expire. Is this the normal way to implement it? Just wait for timeout? Or do I have some CISCO configuration issues?

 

Shouldn’t the CISCO tell FreeSwitch that “Hey … the guy on the line has put down his phone receiver so you can end your session now.”?

 

 

Any comments?

 

voice-port 0/3/0

 input gain 10

 output attenuation 10

 no comfort-noise

 cptone AU

 connection plar opx 1024

 impedance complex1

!

voice-port 0/3/1

!

voice-port 0/3/2

!

voice-port 0/3/3

!

!

!

!

!

dial-peer voice 2 voip

 destination-pattern .T

 session protocol sipv2

 session target sip-server

 session transport udp

 dtmf-relay rtp-nte

 codec g711ulaw

 no vad

!

!

sip-ua

 credentials username 1000 password * ******* realm default

 authentication username 1000 password * ********

 retry invite 2

 retry register 10

 timers connect 100

 registrar ipv4:192.168.255.**:5060 expires 3600

 sip-server ipv4:192.168.255.**:5060

!

 

Regards,

 

 

Oliver Schenk

 

Control Systems Engineer

 

WestNet Rail

 


NOTICE - This e-mail and any files transmitted with it are confidential and are only for the use of the person to whom they are addressed.
If you are not the intended recipient then you have received this e-mail in error; please advise us immediately if this is the case.
Any views expressed in this message are those of the individual sender, except where the sender specifically states them to be the views of WestNet Rail.