On Mon, Aug 10, 2009 at 10:26 PM, Alex Green <alexg@etherstack.com> wrote:

For FXO I switch back to the dialtone state and collect the digits via the ZAP_SIGEVENT_COLLECTED_DIGIT call back (which is a little bit ugly and does not allow dial ahead, but it works).

Sounds way too ugly, I don't think you should be doing that.

DIALTONE' is printed if you try). Openzap must be able to detect digits during a call, but I am having trouble figuring out how.

ie. How do you use Openzap to detect in-band DTMF digits during a call?

Take a look at mod_openzap/mod_openzap.c, on_clear_channel_signal() It seem to me you should do the same. zap_channel_command(sigmsg->channel, ZAP_COMMAND_ENABLE_DTMF_DETECT, &tt); where tt = ZAP_TONE_DTMF and sigmsg->channel is the zap_channel_t That will enable the DTMF detection feature in the channel (either in software or hardware if its available). After enabling that feature, you can use zap_channel_dequeue_dtmf(zchan, dtmf, sizeof(dtmf)); to dequeue DTMF after calling zap_channel_read(), since there is where dtmf (if any) is enqueued. Check zap_channel_read so you can see how the DTMF is detected and enqueued. If you don't want to call zap_channel_dequeue_dtmf on each read (or you can't), then register an event callback for the span with zap_span_set_event_callback(), then your code will be called with ZAP_EVENT_DTMF when dtmf is received in any channel on that span. Hope that helps, -- Moises Silva Software Developer Sangoma Technologies Inc. | 50 McIntosh Drive, Suite 120, Markham ON L3R 9T3 Canada t. 1 905 474 1990 x 128 | e. moy@sangoma.com