Actually the set-up is like below.
1. Freeswitch configured as an UA and registered with sipx proxy.
2. Xlite softphone A is also registered with the same sipx proxy.
3. Another Xlite softphone B is also registered to sipx proxy.
Procedures followed:
1. Make a call from Xlite A to Freeswitch UA. Answer it at Freeswitch UA.
2. Now when the call in step 1 has been successfully established, try to make a another call from Xlite B to Freeswitch UA.
3. So now, if Call Waiting is enabled by default there should be call waiting tone indicating that there is a waiting call at Freeswitch UA. But I didn't hear any.
So where should I configure/enable Call Waiting option to generate Call Waiting tone at Freeswitch UA.
Thanks,
Irshad.On Dec 20, 2007 8:33 PM, Brian West <brian.west@mac.com> wrote:Can you clarify this a bit? Your question leaves me confused as to
what exactly you're asking. What devices are you using?
/b> _______________________________________________
On Dec 20, 2007, at 6:28 AM, Irshad Ahamed wrote:
> Hi,
>
> I couldn't hear any beeps when there is a second incoming call. I
> was of the notion that Call Waiting is enabled by default. If not,
> how should I enable it?? Any pointers buddies.....
>
> Thanks in advance...
>
> Best Regards,
> Irshad.
> Freeswitch-dev mailing list
> Freeswitch-dev@lists.freeswitch.org
> http://lists.freeswitch.org/mailman/listinfo/freeswitch-dev
> UNSUBSCRIBE: http://lists.freeswitch.org/mailman/options/freeswitch-dev
> http://www.freeswitch.org
_______________________________________________
Freeswitch-dev mailing list
Freeswitch-dev@lists.freeswitch.org
http://lists.freeswitch.org/mailman/listinfo/freeswitch-dev
UNSUBSCRIBE:http://lists.freeswitch.org/mailman/options/freeswitch-dev
http://www.freeswitch.org
_______________________________________________
Freeswitch-dev mailing list
Freeswitch-dev@lists.freeswitch.org
http://lists.freeswitch.org/mailman/listinfo/freeswitch-dev
UNSUBSCRIBE:http://lists.freeswitch.org/mailman/options/freeswitch-dev
http://www.freeswitch.org