Hi,

I am experimenting with WebRTC and am failing quite dismally - mainly due to lack of documentation.

I realise this is an emerging technology and the standards are moving, but presumably it does work in some scenarios and it would be great if a working setup could be documented.

Anyway, I think I might have found a bug, but have no way to tell because I've never been able to get WebRTC working with Freeswitch.

Here's my setup so far:


What I am able to do:

If I setup the internal IPv4 profile with ws-binding, I can use SIPJS to register and can successfully see a user registered in Freeswitch from the browser.

I can then use SIPJS to make a call, and my desk phone rings, however I get no media (UDP packets are being sent but presumably neither side can decode it).

I also see these errors in the fs_cli debug output though:

2014-07-27 13:04:12.108836 [ERR] switch_core_cert.c:210 FP FILE ERR!
2014-07-27 13:04:12.108836 [ERR] switch_core_cert.c:210 FP FILE ERR!
2014-07-27 13:04:12.148104 [ERR] switch_rtp.c:2975 audio DTLS cert err [5]

But I can find no proper documentation on what is required for DTLS or where to put the cert files.

Next up I tried IPv6 in the internal-ipv6 profile:

    <param name="tls-cert-dir" value="/etc/freeswitch/certs"/>
    <param name="wss-binding" value=":7443"/>

I concatenated the cert, key and chain certs together into /etc/freeswitch/certs/wss.pem and can successfully connect using WSS and SIPJS.

The problem however is that although I can see a register, Freeswitch then kills the registration connection a couple of seconds later.

It is also showing the registration as using WSS-NAT, how can that be possible on IPv6?

How can I turn off NAT detection on the IPv6 profile?

Any guidance would be very much appreciated and I will post my setup to my blog and the Freeswitch wiki if I can get it working, to help people in the future.

Thanks
Tom