Hi Develop team,
 
Just simlify this question.
 
In the message 100, 180,183, 200 response to the caller side from Freeswitch side, the called part Name should be include in the sip address of "To" & SDP part. It should be  "ABC"<sip: 1234@a.b.c.d>, NOT only <sip: 1234@a.b.c.d>.
 
Currently, at the called part, the caller info is correct with Name. So the display at called side is OK.
 
Could you please let me know where is the source code for such process? I also would like to review it.
 
Thanks!
 
2012-11-30
sparklezou
发件人：sparklezou
发送时间：2012-11-30 15:55
主题：Re: [Freeswitch-users] About the display problem during calling
收件人："freeswitch-dev"<freeswitch-dev@lists.freeswitch.org>
抄送："freeswitch-users"<freeswitch-users@lists.freeswitch.org>
 
Hi All,
 
Before, I saved the user name in the phone. So it will show the name when ringing.
 
From the FreeSwitch side, there is NO difference.
 
@ Develop Team,
 
For Internal call, or any sip call from gateway, it should be better show the Name during ring.  And also keep show the name in the call, in stead of "Outbound Call".
 
Usually the phone will update the display name from the sip response message.
 
So in the 100, 180, 183, 200 sip/sdp message. Respons with the called name, like "ABC"<sip: 1234@a.b.c.d>.
 
Currently in the inital 100,180,183 message, only <sip: 1234@a.b.c.d>. In the 200 message "Remote-Part-ID: "Outbound Call" <sip: 1234@a.b.c.d>; ....... "
 
If it could be updated, then the called name could be displayed on the caller phone.
 
Thanks!
 
2012-11-30
sparklezou
发件人：sparklezou
发送时间：2012-11-30 11:19
主题：[Freeswitch-users] About the display problem during calling
收件人："freeswitch-users"<freeswitch-users@lists.freeswitch.org>,"freeswitch-dev"<freeswitch-dev@lists.freeswitch.org>
抄送：
 
Hi All,
 
I facing a strange problem.
 
Before, when calling Internal number, the name and number will both be displayed on the caller phone. When connected, only the name will display on the phone. At called phone, display the name and number. Seems fine.
 
But yesterday afternoon, when calling Internal number, only the number is displayed on the caller phone. When connected, display "Outbound Call" on the caller phone. At the called phone, everthing is the same. Display both the name and number.
 
I think, mabybe something configured wrong. So I try to restore back the configuration. seems the same. I have to re-install the last release stable 1.2.5.1 version on another server. total fresh setting. But found the same problem.
 
I checked the sip info.
 
The "Outbound Call" is in the 200 SDP message. the called is set to
 
""Remote-Part-ID: "Outbound Call" <sip: 1234@a.b.c.d>; ....... "
 
Not the correct called name.
 
Is there anything wrong?
 
Please help me.
 
Thanks!
 
 
2012-11-30
sparklezou