[Freeswitch-users] Problems migrating from 1.6.x to 1.8.x

Mon Jun 10 16:35:22 UTC 2019

I was under the impression level 7 was the default ?  At least that's what fs_cli shows when I first open it on a clean install ? ('+OK log level  [7]').

I'll try again with an explicit 'fsctl loglevel 7' a bit later and report back ....

‐‐‐‐‐‐‐ Original Message ‐‐‐‐‐‐‐
On Sunday, June 9, 2019 8:59 PM, Giovanni Maruzzelli <gmaruzz at gmail.com> wrote:

> The phones are registering to the sipdomain, that is correctly mapped to the ipaddress?
> Also, if you up the loglevel, you will see what fs "thinks"
>
> From fs_cli: fsctl loglevel 7
>
> On Sun, Jun 9, 2019, 21:48 Laura Smith <n5d9xq3ti233xiyif2vp at protonmail.ch> wrote:
>
> > The certificate is a wildcard certificate, so no issues copying it from one server to another.
> >
> > ‐‐‐‐‐‐‐ Original Message ‐‐‐‐‐‐‐
> > On Sunday, 9 June 2019 20:39, Giovanni Maruzzelli <gmaruzz at gmail.com> wrote:
> >
> > > Check you got the correct tls certificate for the domain, and that the phones are registering to the correct domain. Probably is an ipaddress/sipdomain mismatch, or a certificate mismatch
> > >
> > > On Sun, Jun 9, 2019, 21:34 Laura Smith via FreeSWITCH-users <freeswitch-users at lists.freeswitch.org> wrote:
> > >
> > > > ---------- Forwarded message ----------
> > > > From: Laura Smith <n5d9xq3ti233xiyif2vp at protonmail.ch>
> > > > To: "gmaruzz at opentelecom.it" <gmaruzz at opentelecom.it>
> > > > Cc: FreeSWITCH Users Help <freeswitch-users at lists.freeswitch.org>
> > > > Bcc: 
> > > > Date: Sun, 09 Jun 2019 19:31:25 +0000
> > > > Subject: Re: [Freeswitch-users] Problems migrating from 1.6.x to 1.8.x
> > > > https://pastebin.com/BmXAeS3N
> > > >
> > > > (Stating the obvious, but IP addresses and domain names have been suitably mangled to protect the innocent)
> > > >
> > > > ‐‐‐‐‐‐‐ Original Message ‐‐‐‐‐‐‐
> > > > On Sunday, 9 June 2019 20:10, Giovanni Maruzzelli <gmaruzz at gmail.com> wrote:
> > > >
> > > > > Then, pastebin the complete sip trace
> > > > >
> > > > > On Sun, Jun 9, 2019, 21:07 Laura Smith <n5d9xq3ti233xiyif2vp at protonmail.ch> wrote:
> > > > >
> > > > > > Giovanni,
> > > > > >
> > > > > > Except that's the problem, there are no "errors from console".
> > > > > >
> > > > > > The only reason I know about the 403 Rejected is because I turned on SIP tracing and can see Freeswitch sending a 403 to the SIP phones.
> > > > > >
> > > > > > Otherwise, Freeswitch is being unhelpfully silent.  Turning on debugging just generates a lot of noise but delivers no extra insight, I've tried that too.
> > > > > >
> > > > > > I'm thinking (and perhaps someone here can confirm) whether 1.6->1.8 is the problem ?  Have there been non backwards-compatible changes ?
> > > > > >
> > > > > > ‐‐‐‐‐‐‐ Original Message ‐‐‐‐‐‐‐
> > > > > > On Sunday, 9 June 2019 15:38, Giovanni Maruzzelli <gmaruzz at gmail.com> wrote:
> > > > > >
> > > > > > > Obviously, you need to pastebin somewhere all errors from console and logfile, and put the pastebin link here
> > > > > > >
> > > > > > > -giovanni
> > > > > > >
> > > > > > > On Sun, Jun 9, 2019 at 3:42 PM Laura Smith via FreeSWITCH-users <freeswitch-users at lists.freeswitch.org> wrote:
> > > > > > >
> > > > > > > > ---------- Forwarded message ----------
> > > > > > > > From: Laura Smith <n5d9xq3ti233xiyif2vp at protonmail.ch>
> > > > > > > > To: "freeswitch-users at lists.freeswitch.org" <freeswitch-users at lists.freeswitch.org>
> > > > > > > > Cc: 
> > > > > > > > Bcc: 
> > > > > > > > Date: Sat, 08 Jun 2019 09:14:21 +0000
> > > > > > > > Subject: Problems migrating from 1.6.x to 1.8.x
> > > > > > > > Hi,
> > > > > > > >
> > > > > > > > I have a perfectly functioning FreeSWITCH Version 1.6.20-37-987c9b9~64bit (-37-987c9b9 64bit) instance running on Debian 8 (jessie).
> > > > > > > >
> > > > > > > > I'd like to move onwards and upwards, and so have installed FreeSWITCH Version 1.8.6-7-93b4c92e75~64bit (-7-93b4c92e75 64bit) on Debian 9 (stretch).
> > > > > > > >
> > > > > > > > In the hope that it would be as simple as copying accross /etc/freeswitch from old to new, I did that, followed by a reloadxml and, for good measure, a restart of the entire freeswitch instance.
> > > > > > > >
> > > > > > > > I have, of course, adjusted the relevant parameters in vars.xml in terms of hostname and IP addresses.
> > > > > > > >
> > > > > > > > However the new instance is refusing to allow my endpoints to register.  Its sending 403 forbidden back.
> > > > > > > >
> > > > > > > > Any ideas ?
> > > > > > > >
> > > > > > > > Thanks !
> > > > > > > >
> > > > > > > > Laura
> > > > > > > >
> > > > > > > > ---------- Forwarded message ----------
> > > > > > > > From: Laura Smith via FreeSWITCH-users <freeswitch-users at lists.freeswitch.org>
> > > > > > > > To: "freeswitch-users at lists.freeswitch.org" <freeswitch-users at lists.freeswitch.org>
> > > > > > > > Cc: 
> > > > > > > > Bcc: 
> > > > > > > > Date: Sun, 09 Jun 2019 06:42:56 -0700 (PDT)
> > > > > > > > Subject: [Freeswitch-users] Problems migrating from 1.6.x to 1.8.x
> > > > > > > > _________________________________________________________________________
> > > > > > > >
> > > > > > > > The FreeSWITCH project is sponsored by SignalWire https://signalwire.com
> > > > > > > > Enhance your FreeSWITCH install with disruptive priced SMS and PSTN services.
> > > > > > > > Build your next product on our scalable cloud platform.
> > > > > > > >
> > > > > > > > Join our online community to chat in real time https://signalwire.community
> > > > > > > >
> > > > > > > > Professional FreeSWITCH Services
> > > > > > > > sales at freeswitch.com
> > > > > > > > https://freeswitch.com
> > > > > > > >
> > > > > > > > Official FreeSWITCH Sites
> > > > > > > > https://freeswitch.com/oss
> > > > > > > > https://freeswitch.org/confluence
> > > > > > > > https://cluecon.com
> > > > > > > >
> > > > > > > > FreeSWITCH-users mailing list
> > > > > > > > FreeSWITCH-users at lists.freeswitch.org
> > > > > > > > http://lists.freeswitch.org/mailman/listinfo/freeswitch-users
> > > > > > > > UNSUBSCRIBE:http://lists.freeswitch.org/mailman/options/freeswitch-users
> > > > > > > > https://freeswitch.com
> > > > > > >
> > > > > > > --
> > > > > > > Sincerely,
> > > > > > >
> > > > > > > Giovanni Maruzzelli
> > > > > > > OpenTelecom.IT
> > > > > > > cell: +39 347 266 56 18
> > > >
> > > > ---------- Forwarded message ----------
> > > > From: Laura Smith via FreeSWITCH-users <freeswitch-users at lists.freeswitch.org>
> > > > To: "gmaruzz at opentelecom.it" <gmaruzz at opentelecom.it>
> > > > Cc: FreeSWITCH Users Help <freeswitch-users at lists.freeswitch.org>
> > > > Bcc: 
> > > > Date: Sun, 09 Jun 2019 12:34:24 -0700 (PDT)
> > > > Subject: Re: [Freeswitch-users] Problems migrating from 1.6.x to 1.8.x
> > > > _________________________________________________________________________
> > > >
> > > > The FreeSWITCH project is sponsored by SignalWire https://signalwire.com
> > > > Enhance your FreeSWITCH install with disruptive priced SMS and PSTN services.
> > > > Build your next product on our scalable cloud platform.
> > > >
> > > > Join our online community to chat in real time https://signalwire.community
> > > >
> > > > Professional FreeSWITCH Services
> > > > sales at freeswitch.com
> > > > https://freeswitch.com
> > > >
> > > > Official FreeSWITCH Sites
> > > > https://freeswitch.com/oss
> > > > https://freeswitch.org/confluence
> > > > https://cluecon.com
> > > >
> > > > FreeSWITCH-users mailing list
> > > > FreeSWITCH-users at lists.freeswitch.org
> > > > http://lists.freeswitch.org/mailman/listinfo/freeswitch-users
> > > > UNSUBSCRIBE:http://lists.freeswitch.org/mailman/options/freeswitch-users
> > > > https://freeswitch.com