[Freeswitch-users] The Best Way to Send Fax on Sangoma?

[Anita Hall]

Hi

What should be the optimal settings for HWEC related parameters in
wanpipe1.conf to be able to receive Fax over T.30 on a Sangoma A108DE Card ?

In particular, should I enable echo ? If yes, to what parameter ? What
other values like RXGAIN, TXGAIN should I tune ?

TDMV_HW_DTMF                          = YES           # YES: receive dtmf
events from hardware
TDMV_HW_FAX_DETECT              = YES           # YES: receive fax 1100hz
events from hardware
HWEC_OPERATION_MODE           = OCT_NORMAL    # OCT_NORMAL: echo
cancelation enabled with nlp (default)

# OCT_SPEECH: improves software tone detection by disabling NLP (echo
possible)

# OCT_NO_ECHO:disables echo cancelation but allows VQE/tone functions.
HWEC_DTMF_REMOVAL               = NO    # NO: default  YES: remove dtmf out
of incoming media (must have hwdtmf enabled)
HWEC_NOISE_REDUCTION           = NO    # NO: default  YES: reduces noise on
the line - could break fax
HWEC_ACUSTIC_ECHO                 = NO    # NO: default  YES: enables
acustic echo cancelation
HWEC_NLP_DISABLE                    = NO    # NO: default  YES: guarantees
software tone detection (possible echo)
HWEC_TX_AUTO_GAIN                 = 0     # 0: disable   -40-0: default tx
audio level to be maintained (-20 default)
HWEC_RX_AUTO_GAIN                 = 0     # 0: disable   -40-0: default tx
audio level to be maintained (-20 default)
HWEC_TX_GAIN                            = 0             # 0: disable
-24-24: db values to be applied to tx signal
HWEC_RX_GAIN                            = 0             # 0: disable
-24-24: db values to be applied to tx signal


regards,
Anita
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.freeswitch.org/pipermail/freeswitch-users/attachments/20120327/3843180e/attachment.html