[Freeswitch-users] DTMF on BLeg not recognized by Cisco Gateway

[Yehavi Bourvine]

Hi,

  Yes, you need two profiles - one for incoming and one for outgoing. I
enclose here the relevant fragments from my old config:

voice service voip
 qsig decode
 dtmf-interworking rtp-nte    (RFC-2833)
 srtp fallback
 allow-connections sip to sip
 fax protocol t38 ls-redundancy 4 hs-redundancy 2 fallback cisco
Not sure this is relevant:

interface Serial0/0/0:15
 no ip address
 encapsulation hdlc
 isdn switch-type primary-qsig
 isdn overlap-receiving
 isdn not-end-to-end 64
 isdn incoming-voice voice
 isdn supp-service name calling profile Network-Extension
operation-value-tag local
 isdn negotiate-bchan
 isdn outgoing ie facility
 isdn outgoing ie notify-indicator
 isdn outgoing display-ie
 isdn outgoing ie caller-number
 isdn outgoing ie called-number
 no cdp enable
This is for calls from PSTN to VoIP:

dial-peer voice 201 voip
 destination-pattern 40.....
 progress_ind setup enable 1
 progress_ind progress enable 8
 session protocol sipv2
 session target ipv4:10.1.1.1:5070  Note the special port - it lands on
a different profile
 session transport udp
 dtmf-relay sip-notify          Use INFO/NOTIFY instead of RFC-2833
 codec g711alaw
 fax-relay sg3-to-g3
 fax protocol t38 ls-redundancy 4 hs-redundancy 2 fallback cisco
 no vad

The VoIP to PSTN has nothing special:
dial-peer voice 1 pots
 destination-pattern 8T
 progress_ind setup enable 3
 progress_ind progress enable 8
 no digit-strip
 direct-inward-dial
 port 0/0/0:15

                   Regards, __Yehavi:

2012/4/26 <bernard.david.murphy at gmail.com>

> To do that I'd have to have another sip profile for inbound call legs on a
> different port I suppose ?
>
> Sent from my BlackBerry® wireless device
>
> -----Original Message-----
> From: Yehavi Bourvine <yehavi.bourvine at gmail.com>
> Sender: freeswitch-users-bounces at lists.freeswitch.org
> Date: Thu, 26 Apr 2012 12:20:56
> To: FreeSWITCH Users Help<freeswitch-users at lists.freeswitch.org>
> Reply-To: FreeSWITCH Users Help <freeswitch-users at lists.freeswitch.org>
> Subject: Re: [Freeswitch-users] DTMF on BLeg not recognized by Cisco
> Gateway
>
> _________________________________________________________________________
> Professional FreeSWITCH Consulting Services:
> consulting at freeswitch.org
> http://www.freeswitchsolutions.com
>
> 
> 
>
> Official FreeSWITCH Sites
> http://www.freeswitch.org
> http://wiki.freeswitch.org
> http://www.cluecon.com
>
> FreeSWITCH-users mailing list
> FreeSWITCH-users at lists.freeswitch.org
> http://lists.freeswitch.org/mailman/listinfo/freeswitch-users
> UNSUBSCRIBE:http://lists.freeswitch.org/mailman/options/freeswitch-users
> http://www.freeswitch.org
>
> _________________________________________________________________________
> Professional FreeSWITCH Consulting Services:
> consulting at freeswitch.org
> http://www.freeswitchsolutions.com
>
> 
> 
>
> Official FreeSWITCH Sites
> http://www.freeswitch.org
> http://wiki.freeswitch.org
> http://www.cluecon.com
>
> FreeSWITCH-users mailing list
> FreeSWITCH-users at lists.freeswitch.org
> http://lists.freeswitch.org/mailman/listinfo/freeswitch-users
> UNSUBSCRIBE:http://lists.freeswitch.org/mailman/options/freeswitch-users
> http://www.freeswitch.org
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.freeswitch.org/pipermail/freeswitch-users/attachments/20120427/a81ef8a4/attachment.html