[Freeswitch-users] Share PRI line?

[shouldbe q931]

On Thu, Sep 22, 2011 at 2:23 PM,  <fssupport at highergear.com> wrote:
>> On Wed, Sep 21, 2011 at 6:20 PM,  <fssupport at highergear.com> wrote:
>>> We have a client with a Mitel PBX with a PRI connected to it.  We are
>>> deploying a freeswitch box that will do some autodialing tasks for them.
>>> Is there a way to share the PRI between the two systems?  If nothing
>>> else,
>>> I'm pretty sure I can put a two line interface card in the Freeswitch
>>> server, plug the pri into it, then connected the other interface to the
>>> Mitel box, but that would make our box a point of failure and I'd like
>>> to
>>> avoid that if possible.
>>>
>>
>> It is not possible to "split" or "share" a PRI interface with passive
>> components, your three options are
>>
>> a/ put a second PRI interface onto "your" system, and configure it to
>> route inbound calls to the Mitel system and outbound calls from the
>> Mitel system
>> b/ put a second PRI interface onto the Mitel, and configure it as per
>> a/ but with your system instead
>> c/ purchase a device with 3 PRI interfaces that can route inbound
>> calls and outbound calls appropriately as per a/ and b/
>>
>>
>> FreeSWITCH-users mailing list
>> FreeSWITCH-users at lists.freeswitch.org
>> http://lists.freeswitch.org/mailman/listinfo/freeswitch-users
>> UNSUBSCRIBE:http://lists.freeswitch.org/mailman/options/freeswitch-users
>> http://www.freeswitch.org
>>
> Thanks for your response on this.  With regards to option c, I found this:
> http://www.patapsco.co.uk/Products/Liberator/ISDN_Splitter_ISDN-Converter_Liberator_s.html
> I think this might be what I need?
>
>
>

this might be more appropriate
http://www.patapsco.co.uk/Products/Liberator/Liberator_Q_4-Port_PRI_ISDN_Switch.html

however a 2nd PRI card in the Mitel would probably be more cost effective