[Freeswitch-users] does FreeSWITCH care about beeing connected to an IPv4- or IPv6-ISP ?
avi at avimarcus.net
Tue Jun 28 15:02:06 MSD 2011
Just to clarify: each sip profile binds to ONE and only ONE IP address. That
can be ipv4 external, local, ipv6, whatever, but you need a separate profile
for EACH IP you wish to get calls on.
On Tue, Jun 28, 2011 at 11:00 AM, Steven Ayre <steveayre at gmail.com> wrote:
> You can use SIP on FS on IPv4, IPv6, or both. You can even bridge calls
> inbetween the two (as long as you avoid bypass_media).
> When you create a SIP profile it binds to a specific IP, you just need to
> put the relevant IPv4/IPv6 IP there. Then treat the profiles as normal. ACLs
> also support IPv6 addresses.
> Not sure about what the support is in other modules such as mod_h323
> On 27 June 2011 17:15, bill evergreen <bill.evergreen at gmail.com> wrote:
>> I intend to setup a little FreeSWITCH test-environment. Does FreeSWITCH
>> care about beeing connected to an IPv4- OR IPv6-isp (it should be possible
>> to operate the same environment under IPv4 OR IPv6) ?
>> Thank's a lot for any feedback!
>> I am new to FreeSWITCH :-)
>> Join us at ClueCon 2011, Aug 9-11, Chicago
>> http://www.cluecon.com 877-7-4ACLUE
>> FreeSWITCH-users mailing list
>> FreeSWITCH-users at lists.freeswitch.org
> Join us at ClueCon 2011, Aug 9-11, Chicago
> http://www.cluecon.com 877-7-4ACLUE
> FreeSWITCH-users mailing list
> FreeSWITCH-users at lists.freeswitch.org
-------------- next part --------------
An HTML attachment was scrubbed...
More information about the FreeSWITCH-users