[Freeswitch-users] 2 endpoints behing NATs

[Stas Khirman]

No, I used default FreeSWITCH configuration from 1.0.6 distribution.

 

Where have I look to enable fs_nat functions?

 

From: freeswitch-users-bounces at lists.freeswitch.org
[mailto:freeswitch-users-bounces at lists.freeswitch.org] On Behalf Of Michael
Jerris
Sent: Friday, September 03, 2010 9:58 AM
To: FreeSWITCH Users Help
Subject: Re: [Freeswitch-users] 2 endpoints behing NATs

 

This should already be enabled in the default configuration.  Have you
modified anything of note related to ip's, acl's, or nat settings from the
default configs?

 

Mike

 

On Sep 1, 2010, at 7:36 AM, Stas Khirman wrote:





David ,

 

Thank you for such prompt response!

 

I checked my X-Lite configuration and find that "Use rport" had been
checked.

However, Registration doesn't include anything about fs_nat(see below). Do I
need explicitly configure/load RTP proxy support? If yes, will appreciate
instructions.

 

-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.freeswitch.org/pipermail/freeswitch-users/attachments/20100903/777ca7cb/attachment.html