[Freeswitch-users] SIP and nat traversal IPv4/IPv6 issue

[Brian West]

I need in one of your boxs... there is no way this is doing this  
unless you are putting stun:stun.freeswitch.org into the ext-rtp-ip or  
sip ip... which could make it trigger the ipv6 check since its just  
looking for : in the ip address.  And stun: has that.. so you're  
triggering it... tar up your entire conf folder and mail it to me ASAP.

/b

On Jun 17, 2009, at 8:01 PM, Jason White wrote:

> Raul Fragoso <raul at etellicom.com> wrote:
>> I can confirm the same issue, but it happens even with all the IPv6
>> stuff removed.
>
> Thank you for the corroboration.
>
> It only happens to me if I have the following in my external.xml  
> profile:
> <param name="local-network-acl" value="localnet.auto"/>
>
> Note that I need the above line for nat traversal; if I leave it out,
> FreeSWITCH uses a private IPv4 address in outgoing invites, and can't
> establish a call.
>
>
> _______________________________________________
> Freeswitch-users mailing list
> Freeswitch-users at lists.freeswitch.org
> http://lists.freeswitch.org/mailman/listinfo/freeswitch-users
> UNSUBSCRIBE:http://lists.freeswitch.org/mailman/options/freeswitch-users
> http://www.freeswitch.org