[Freeswitch-users] Freeswitch taking too long to start up

[Muhammad Shahzad]

I do understand the importance of NAT, i just want to know where it sends
ICMP ping (refer to NiK reply below) to compute NAT type? Right now i am
enhancing a few FS modules for a specific business model. Once it is done
and fully tested, i would put it in production, where i have to take care of
NAT issues as well. So, if i know its NAT detection mechanism, it would be
easier for me to configure it properly during production deployment.

Also if my employer approves, i would like to share my customization (fully
or partially) with FS community. How can i get a developer account? What
else is required to become an official FS developer?

Thank you.


On Wed, Jun 3, 2009 at 7:18 PM, Brian West <brian at freeswitch.org> wrote:

> You shouldn't have to use the switch anymore.  That is unless you just
> wanna skip that check.
> /b
>
> On Jun 3, 2009, at 12:09 AM, Muhammad Shahzad wrote:
>
> I had to upgrade again svn revision to use this switch, but it works.
>
> Thank you.
>
>
> Brian West
> brian at freeswitch.org
>
> -- Meet us at ClueCon!  http://www.cluecon.com
>
>
>
>
>
> _______________________________________________
> Freeswitch-users mailing list
> Freeswitch-users at lists.freeswitch.org
> http://lists.freeswitch.org/mailman/listinfo/freeswitch-users
> UNSUBSCRIBE:http://lists.freeswitch.org/mailman/options/freeswitch-users
> http://www.freeswitch.org
>
>


-- 
Muhammad Shahzad
-----------------------------------
CISCO Rich Media Communication Specialist (CRMCS)
CISCO Certified Network Associate (CCNA)
Cell: +92 334 422 40 88
MSN: shari_786pk at hotmail.com
Email: shaheryarkh at googlemail.com
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.freeswitch.org/pipermail/freeswitch-users/attachments/20090604/d233072f/attachment-0002.html