[Freeswitch-users] Configuring Sangoma U100

[Merul Patel]

> What is the output of wantouter hwprobe?

voyage:~# wanrouter hwprobe

-------------------------------
| Wanpipe Hardware Probe Info |
-------------------------------
1 . U100       : BUSID=1-1 : V=00

Card Cnt: U100=1

voyage:~# dahdi_hardware
usb:001/002          wanpipe-     10c4:8461 Sangoma WANPIPE USB-FXO  
Device


>
> On Aug 3, 2009, at 3:12 AM, Merul Patel <merul at mac.com> wrote:
>
>>>> I'm new to FS, and experimenting with it on a constrained
>>>> environment (PCEngines ALIX board running Voyage Linux 0.62).
>>>>
>>>> So far, FS has compiled fine, and I can register multiple
>>>> softphones and make calls between them, but I'm lost at how to
>>>> configure a Sangoma U100 so I can make and receive calls over an
>>>> analogue line.
>>>>
>>>> I've installed the wanpipe drivers (3.5.4) from Sangoma, and the
>>>> wanrouter utility detects the USB device, and I've compiled it to
>>>> support the TDM API.
>>>>
>>>> FS was compiled with the Openzap module - as best as I can tell.
>>>>
>>>> I thought that I would be able to use the wancfg_tdmapi utility to
>>>> configure the /etc/wanpipe/wanpipe1.conf and then use the generated
>>>> configuration file as the basis for configuring autoload_configs/
>>>> openzap.conf.xml.
>>>
>>> try wancfg_fs
>>
>> Thanks for the suggestion Michael, but the same result occurs as when
>> I try wancfg_tdmapi, ie:
>>
>> "No Sangoma voice compatible cards found/configured"
>>
>>>
>>>> However, the wancfg utility doesn't generate the wanpipe1.conf, and
>>>> I'm stumped.
>>>>
>>>> Any pointers would be much appreciated.
>>>>