[Freeswitch-users] close channels properly

[Carole O.]

Hello,

When I do a "show channels" in the cli the channels to the speakers are
listed even if the speakers have stopped transmitting. If I call the
speakers again freeswitch create new channels. If I do a "show channels"
again I can see the old and new ones. If I can keep doing this, each time
new channels are created while the old ones are still there.
I have noticed after 5 minutes the channels that are not used anymore close.
I believed there was a kind of timeout to detect the channels that are not
in use.

What I would like to know is if there is a way to close from these channels
the dialplan .

Thanks,
Carole




Brian West-3 wrote:
> 
> What do you mean they close (hangup) after the 5 minute timeout?
> 
> /b
> 
> On Dec 22, 2008, at 7:35 AM, Carole O. wrote:
> 
>> 1021 and 1022 are the speakers.
>> At the end of the announcement, since there is no noise anymore, the
>> speakers stop listening but they do not send any messages to tell  
>> Freeswitch
>> it can close the opened channels. The channels are closed only after a
>> timeout of 5 minutes.
>>
>> Does anybody know how I could force freeswitch to close all the  
>> channels
>> after the announcement? I have seen there is the application  
>> sched_hangup
>> but when I used it it only closes the channel to the caller and not  
>> the
>> other ones.
> 
> 
> _______________________________________________
> Freeswitch-users mailing list
> Freeswitch-users at lists.freeswitch.org
> http://lists.freeswitch.org/mailman/listinfo/freeswitch-users
> UNSUBSCRIBE:http://lists.freeswitch.org/mailman/options/freeswitch-users
> http://www.freeswitch.org
> 
> 

-- 
View this message in context: http://www.nabble.com/close-channels-properly-tp21127913p21140461.html
Sent from the Freeswitch-users mailing list archive at Nabble.com.