[Freeswitch-dev] Doubt on bridge programatically

[João Mesquita]

I think you can check the cause from one of the function parameters.
Check the function signature or look atthe bridge application on
mod_dptools.

JM

On Saturday, June 26, 2010, Juan Antonio Ibañez Santorum
<juanito1982 at gmail.com> wrote:
> The problem of 3rd option is that a need to use one or more failover trunk if main trunk fails.
>
> At point 1, how can I get if originate was ok, busy, congestioned? Is possible getting originate result when switch_ivr_originate() returns? or may I need make use of events?
>
> Regards
>
> 2010/6/26 Mathieu Rene <mrene_lists at avgs.ca>
>
> Hi,
>
> >From a module you have a few choices:
> 1- Call switch_ivr_originate() to establish a new session, then call switch_ivr_uuid_bridge() with both uuids (you can get the uuid using switch_core_session_get_uuid())
> 2- Execute the "bridge" application directly with switch_core_session_execute_application()
> 3- Transfer the session to the dialplan again so it can be bridged out (using the bridge app)
>
> Dialstrings are all handled in switch_ivr_originate(), which is the main function used to make an outbound call, all features such as forked dialing and failover will work when calling either switch_ivr_originate(), or the bridge application.
>
> Personally I'd go for the 3rd choice, if you need to interact with the session while its bridged, you can always do so by using one of freeswitch's hooking methods (events, io hooks, state handlers).
>
> Cheers,
>
> Mathieu Rene
> Avant-Garde Solutions Inc
> Office: + 1 (514) 664-1044 x100
> Cell: +1 (514) 664-1044 x200
> mrene at avgs.ca
>
>
>
>
> On 2010-06-25, at 6:11 PM, Juan Antonio Ibañez Santorum wrote:
>
>> Hello!
>>
>>    I am working on a module having this doubt:
>>
>> Once a call reachs to dialplan I call my app and I don't know which is the best way (if more than one exits) to bridge that call to an onbound provider controlling failed connections to try with a failure trunk. Is there any way to get call connection status (BUSY, CONGESTION...) from code? Is necessary to use events or may it be obtained as result of bridge function?
>>
>> Regards
>> _______________________________________________
>> FreeSWITCH-dev mailing list
>> FreeSWITCH-dev at lists.freeswitch.org
>> http://lists.freeswitch.org/mailman/listinfo/freeswitch-dev
>> UNSUBSCRIBE:http://lists.freeswitch.org/mailman/options/freeswitch-dev
>> http://www.freeswitch.org
>
>
> _______________________________________________
> FreeSWITCH-dev mailing list
> FreeSWITCH-dev at lists.freeswitch.org
> http://lists.freeswitch.org/mailman/listinfo/freeswitch-dev
> UNSUBSCRIBE:http://lists.freeswitch.org/mailman/options/freeswitch-dev
> http://www.freeswitch.org
>
>

-- 
João Mesquita
FreeSWITCH™ Solutions
t: +1 (646) 4959927